Learn › Setting up inputs › Set your preamp gains

Set your preamp gains

Set up5 stepsRouting › Inputs

Every sound in the mix starts at the preamp on your console. With the band playing, the Inputs page tells you, for each channel, which way to turn the preamp at the desk and by how much.

Before you start
  • The console connected and chosen on Routing › Audio device
  • Each input named and set to what it is
  • The band ready to play as loud as they will

1Open Inputs while the band plays

Open Routing › Inputs in the sidebar. Ask the band to play a song at full performance level, not a quiet soundcheck, so the levels you set hold up during the set.

2Read the Level column

Each input gets a verdict from its loudest moment: Healthy, Low, Faint, Hot, Clipping, Digital, Spill or Not heard. The number beside it, such as Low +8 or Clipping −6, is how far to turn the preamp, in dB.

Level

01KickDrumsHealthy
02SnareDrumsLow +8
09Lead voxLeadClipping −6
12HostSpeechHealthy
14ChoirBGVNot heard

3Make the move, then walk back

Turn the preamp on the console, not a fader in DINE. The level bar holds the loudest moment and falls slowly, so you can make the change on stage and still read it at the desk. Press Check again to forget the old reading.

4Clear the count

While any input needs a move, a banner over the table says how many inputs want the preamp moved, and the foot of the page says it again. When it is gone, press Continue. These verdicts use the same ranges as Check inputs and TUNE MIX, so a soundcheck and a tune never disagree.

5Save the patch for next week

Press Patch › Save this patch… to store every channel, name, source and stereo pair. Next week, Patch › Apply a saved patch… sets the desk in one go. Saved patches also live on the Patches tab of Routing.

Did this help?