Start at the source
Gain staging: a clean, healthy signal before anything else.
Why the preamp comes first
Every stage after the preamp works with what the preamp gives it. Too little, and you make it up later with digital gain, which lifts the hiss and the room along with the voice. Too much, and the signal clips: a hard, crackly distortion no plug-in can undo.
So the first job is a healthy level at the source. Not loud, not quiet: comfortably in the middle, with room above the loudest moment.
Set it with the real performance
Set gains while the band plays as loud as they will on the day. Musicians play harder in the real thing than in a quiet line check, and a level set too politely clips in the first chorus.
Singers and speakers are the same: ask the lead singer for the loudest line of the set, and anyone speaking to talk at full presenting volume, not to count to ten.
One word per input
DINE reads each input against the healthy range for that kind of source. On Check inputs, OK is inside it, LOW is below it, HOT is above it, CLIP means the converter clipped and SILENT has nothing above −60 dBFS for three seconds. The Inputs page says the same in plain words, such as Healthy or Low +8, with how far to move the preamp. The Inputs page, Check inputs and TUNE MIX all use the same ranges, so they never disagree.
Check what stuck
Answer all three to pass this lesson.